System-Specific Installation Workflows
Review formwork plans, rebar layout, and pour specs
Confirm forms, ties, mix additives on site
Confirm base prep, moisture, and form alignment
Sequence after rebar set, form setup
Assign crew trained in specialty concrete finish
Place, screed, edge per slab system steps
Use stakes, forms, additives listed in mix spec
Dry-fit screed, check depth and slope
Slump, finish, edge check per pour
Slump, broom, cure checks
Rework cold joint or low spot
Snap pour, screed, finish photos
Schedule form/pour inspect
Submit mix certs, slab warranty
Provide slab care and curing info
👈 Use this SOP template inside Subtrak
Edit with AI. Customize in seconds. Store and share all your SOPs and checklists in one place.