Standard Field Installation Procedures
Review wiring diagrams and panel layout
Verify box cutouts and rough wire layout
Confirm conduit, boxes, and wire reels
Review lockout/tagout and PPE compliance
Mark conduit paths and fixture locations
Pull wires and terminate per circuit plan
Use proper wire nuts, clamps, and depths
Use code-approved clamps and anchors
Check box locations and device height
Check connections and grounding
Replace or tighten electrical devices
Bag wire, clippings, and trash
Switch, outlet, and light test
Log fixture install photos
👈 Use this SOP template inside Subtrak
Edit with AI. Customize in seconds. Store and share all your SOPs and checklists in one place.